Learn how to set up and use your new Vicks Warm Steam Vaporizer – V150.
If you still have questions, please reach out to our Consumer Relations team by emailing us at [email protected]. We are here to help!
__________
To get the most out of your Vicks Warm Steam Vaporizer, follow these helpful steps.
Make sure your vaporizer is on a firm, level, waterproof, heat-resistant surface at least six inches from the wall, four feet away from bedside, and out of reach of children and pets.
To fill, unlock the steam unit from the water container by turning it counter clockwise.
Fill the water tank up to the water line with cool water, secure the steam unit back into the water container. Hold for 10 seconds to allow water to enter the unit and seat properly in the water container. Ensure that the steam unit is locked securely.
To use your vaporizer with Vicks VapoSteam, add one tablespoon of the inhalant to the medicine cup or to the water container.
To use Vicks VapoPads, insert in the VapoPad into the scent pad slot. Up to two pads can be inserted.
Plug the vaporizer into the wall outlet and wait 10-15 minutes for visible mist to appear. The night-light will remain on, indicating the vaporizer is plugged in.
If the vaporizer fails to steam, unplug the vaporizer from the electrical outlet and allow it to cool. Remove the steam unit allowing the water to drain out, add one or two pinches of salt to the water and mix thoroughly.
Replace the steam unit and plug in the vaporizer. It should steam within 5 minutes.
Use caution when adding salt. Too much can cause excessive boiling, blown fuse, or tripped circuit breaker.
When your vaporizer is out of water it will automatically shut off.
After each use, empty any unused water from the water container, rinse thoroughly, drain and wipe dry.
